|Material:||Synthetic - Rubber||Product Name:||Particles Surface Pavement Marking Tapes|
|Thickness:||0.5mm -0.8mm||Width:||15cm, 20cm, 25mm, 45cm, 100cm|
|Length:||60m||Application:||Highways And Graded Roads, Parking Lot|
Anti Stain Pavement Marking Tape,
Anti Slip Pavement Marking Tape,
Synthetic Temporary Striping Tape
Permanent Anti-stain & Anti-slip Pavement Marking Tapes (Particles Surface)
The surface is free of glass beads, flat, and easy to clean. The base material of the preformed material is composed of polymer flexible polymer rubber, fillers, pigments, etc., and a layer of high wear-resistant and environmentally friendly paint is planted on the surface.
|Nature||General data||Unit||Test Methods|
|Water resistance||pass||pass||--------||GB/ T24717|
|Acid resistance||pass||pass||--------||GB/ T24717|
|Retroreflection||250||150||mcd/m 2 /lux||GB/ T24717|
|Minimum adhesion||25||25||N/25mm||GB/ T24717|
|Anti-skid value||45||45||BPN||GB/ T24717|
1. The road marking tape can be divided into two types: with adhesive backing and without adhesive backing. The type without adhesive backing is commonly used in special environments and with special materials, such as two-component AB glue, 502 glue, and other adhesives for bonding.
2. The products with adhesive backing can be further categorized based on their actual usage, whether to apply primer or not: Without brush primer on the ground: It can be directly applied to smooth and flat surfaces without applying primer. Brush primer on the ground: It should be applied with primer on uneven surfaces or walls (e.g., Pattex Contact Adhesive, Maxbond UL 1603HFR-HS). The amount of primer required depends on the smoothness of the bonding surface, approximately 1 kilogram per 3 to 5 square meters. Please refer to the construction instructions when using the primer.
Item No.: KT2001(without release paper), KT2011(with release paper)
Colour: two-colour,three-colour,four-colour, multi-colour
Pre-formed coloured floor markings can be produced in different sizes, shapes and colours.
|Product Code||Length(m)||Width(cm)||Thickness(mm)||Weight(±10%)||Conventional packaging|
Used for marking lines when the road is temporarily diverted, and is a short-lived product. Directly adhered to the ground, the service life is usually 1-3 months depending on the road condition, traffic flow, and installation.
Depending on road conditions, traffic flow, and installation, the service life is usually 1-3 months.
Contact Person: sales