One-stop Service Provider for All Kinds of Tapes.

PVC electrical insulation tape: Operation method of insulation tape

by:Kint      2020-01-06
Insulating tape is widely used in electrical work such as wire binding, joint, insulation sealing, etc. , which are used under 380V voltage. There are two kinds of production processes: wiping glue and coating glue. Manufacturing process: PVC film is used as the base material and coated with rubber pressure sensitive adhesive. Electrical insulation tape is commonly known as electrical tape (Hereinafter referred to as insulating tape) , Is a special adhesive tape used for insulation such as electrical wiring. In the past, adhesive tape type insulating adhesive tape, I . e. black insulating adhesive tape, was always used on electrical wiring. Its base tree (Back material)It is woven with insulating material. With the progress of science and technology and the development of economy, there are many types of insulating tapes, but the common ones are: polyvinyl chloride and polyolefin insulating tapes. PVC electrical insulation tape> PVC electrical insulation tape manufacturers tell you the operation method of insulation tape: in the process of using electricity, although people have noticed that the cross-sectional area of power cord materials has an impact on the safe use of electricity, however, the use of insulating tape for joints is often not paid enough attention. The laying of power lines is becoming more and more complicated, including under the wood floor, in the wall, in the partition board and in the wet underground or in the water. If the insulating tape is not used properly, leakage will occur, endangering personal safety. Therefore, we should use insulating tape correctly. The power cord connector is divided into '-', '-' and 'T. The joint should be tightly wrapped, smooth and free of burrs. Otherwise, before the line head is disconnected, it should be gently pressed with a wire cutter, then wound to the pressure opening, and then left and right, the thread will be disconnected at the joint. If the joint is in a dry place, first wrap 2 layers with insulating black tape, then wrap 2 layers with plastic tape, then use insulating self-adhesive tape to lengthen about 200% and wrap 2 ~ 3 layers, then wrap 2 layers of plastic tape.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...